Follicly disabled scalp so can't tell whether the shampoo lathers better!įor those people on here with these non-electrical water softeners, hoping they can shed some light on the following.
I'm waiting for a water hardness test kit to arrive to prove the I have soft water as I can't tell by taste and too early to tell whether the glass on shower gets scummy. Okay, I re-plumbed the unit and did two manual regenerations which flushed the resin without issue as far as I can tell. Is it perhaps in regeneration mode (see first pic)? Or perhaps an o-ring needs replacing in the fill valve? Or as it's a float valve it will stop filling when the desired water level is reached? I turned the water off in case this isn't supposed to happen! So I imagine if the above instructions are correct, then my unit should not be filling up! Video attached to show the water running out of fill valve below. Is that supposed to happen? I'm guessing not as instructions state the water softener compartment should be filled manually with a jug of water:
So having installed all pipework, turned off bypass valve and opened up the valve to the unit, I can hear twin tanks fill, but then starts squirting out of the fill valve ( the pipe thing mounted on the side, between the two tanks.). I don't have any user/install instructions apart from what I have found on the web. Okay, following on from my post here (where I purchased a used Harvey twin tank softener) I have now gotten round to finally installing the unit:
0 kommentar(er)
